I picked up a set of bodywork over the summer which I have been rocking in an awesome shade of primer gray for a couple of months. Now that the bike's up for the winter I am going to rattle can a paint job onto it. I have zero experience w/painting bodywork, so looking for a bit of advice. I'm not going for a flawless finish, but if there are a couple of easy steps I can take to make it come out better I'd be all ears.
Right now the bodywork has the primer from the manufacturer on it, and it's in pretty good shape. I was planning on hitting it with a 3M sanding pad, wiping it down and then spraying it, any suggestions on additional steps? My plan is also to do a two tone paint job so any recommendations on how to mask it off/what kind of tape to use would be awesome.,
TIA!
RCKT GRL:
I know a few guys on the MNSBR forum have done this with fantastic results. U may wish to post there as well (in the track sub-group) & see what u sort of answers u get. I'd have to say that the blue painters tape we use to tape off lights & such for DCTC days would work great. Comes off easy and zero residue. ;D
Keep us posted with updates & pics ~D
dl:
I was thinking that they even make rattle can paint for plastic these days. I'm pretty sure when the professionals paint auto bumpers they add a chemical to the paint to keep it somewhat more flexible for the plastic bumper. Don't know if that would be needed for your bike though.
Jvs:
I ended up doing this on my fairings and overall it Turned out pretty good with a little hard work and a lot Of time. Sanding is where you'll need to focus if You want a nice looking paint job. Use a fine grain sandpaper to wet sand So you can get everything real smooth. Use thin coats to avoid dripping and I'd suggest hanging what your painting up so you can spray at eye level. There is also plastic specific paint that sticks real well that you can pick up at menards that works well.. Good winter project eh :)
tk:
blue painters tape
I agree with D. This tape comes off clean and leaves zero residue.